Dress My Craft

LED Cordless Glue Gun

Specifications:
- Input Power: 3.7 Volt Battery
- Power: 10W
- Glue Stick Dimensions: 7mm to 7.5mm (0.28")
- Battery Choice: UL Approved 3.7V, Flat-top Model 18650 Lithium-ion Battery (max capacity 2600mAh or below)
- Run Time: 1.5 to 2 Hours
- Charge Time: 2 to 2.5 Hours
- Contents: Battery Glue Gun, User Manual, UL Approved Lithium Battery, USB Type-C Cable, Screwdriver
- Looking for glue sticks? Click on the link below:
Hot Melt Glue Stick - 7.5 Mm

Uses:
1. For first-time use, remove the isolator pull tab (if any).
2. Connect the charging cable to the glue gun and the other end to a 5V 1A adapter. Charge until the battery is full and the indicator at the rear of the glue gun turns green.
3. Turn on the glue gun. The indicator will turn blue. Insert a glue stick and wait approximately 2 minutes for the glue gun to heat up and melt the glue stick.
4. Hold the glue gun tightly, place the nozzle close to the surface, and aim with the LED light for accurate application.
5. Use two fingers to pull the feed trigger until glue flows out from the nozzle.
6. When the glue stick is used up, point the glue gun down and insert a new glue stick.
7. If the trigger is hard to pull, allow the gun to heat up for a few minutes.
8. Turn off the glue gun when finished using.
9. Always allow the glue gun and the nozzle to completely cool before storage. Store in a cool, dry place away from direct sunlight. Keep out of reach of children.
10. Charge the glue gun when the indicator light and illumination become dim or start flashing.

WARNING:
- Do not touch the nozzle of the glue gun.
- Do not immerse in water.
- Ensure the glue gun is cool before storage.
- Do not remove the battery when in use or turned on.
- Keep out of reach of children.

Glue Gun FAQ

Intended Use: The Battery Glue Gun is intended for applying hot melt adhesives. Do not use the appliance in any way other than the intended use.

Made in Taiwan

Additonal List For Clear Ball Keychain Class

Products Used